Sony SNC-Z20N Manual De Instalación página 34

Note
Insert the PC card with its front side (B
mark) downward. Make sure that the PC
card is fully pushed in.
B
5 Lid
Pull to remove the lid. To replace, push
it in fully to the end.
6 POWER indicator (green)
When the power is supplied to the
camera, the camera starts checking the
system. If the system is normal, this
indicator lights up.
If a system error occurs, this indicator
flashes every second. In this case,
consult your authorized Sony dealer.
7 Tripod adapter
Use this adapter when attaching the
camera to a tripod (screw: 1/4", 20
UNC)
The following mounting screw can be
used.
U1/4", 20 UNC
(ISO standard) (with the
screws are fastened)
Caution
Use the mounting screw whose length is
4.5 mm – 7 mm only. Use of other
screws may cause improper mounting
and damage parts inside the camera.
8
GB
Location and Functions of Parts and Controls
mark
= 4.5 mm – 7 mm
Rear
8 9 0
TELE
ZOOM
WIDE
10 9 8 7 6 5 4 3 2 1
qf
8 WIDE button
Press this button to zoom out.
To reverse the image, press the WIDE
button and TELE button simultaneously
for more than 1 second.
9 TELE (telephoto) button
Press this button to zoom in.
To reverse the image, press the WIDE
button and TELE button simultaneously
for more than 1 second.
T (video output) connector
q;
(BNC type)
Outputs a composite video signal.
Connect to a composite video input
connector of a video monitor, VCR, etc.
qa DC 12 V/AC 24 V (power input)
terminal
Connect to a 12V DC or 24V AC power
supply system.
qs Wire rope mounting screw hole
When installing the camera to the ceiling
or the wall, secure the supplied wire rope
to this hole using the supplied shoulder
screw.
qa qs qd
+ DC 12V –
2 AC 24V 1
qg qh