Improve efficiency.
•Leave the disinfecting agent to act for the
contact time required. If left less time than
required, disinfection may be ineffective.
•In order to carry out the various operations
correctly, you must proceed from up
downwards, finishing with the floor.
•After applying disinfecting agent, remove
residues with a final rinse.
•Pay utmost care to clean the discharge
opening.
•Dry thoroughly the surfaces to avoid bacteria
proliferation due to moisture;
•We recommend you alternate every 6 months
the type of disinfecting agent to avoid
developing resistant forms of bacteria.
Bacteria spores are the most resistant
biological forms and, therefore, it is
recommended you use chloride-based
products.
TROUBLESHOOTING
•Machine does not cool:
•Check that the power plug is properly
inserted and the appliance has electrical
energy.
•The safety device of the compressor comes
into action: wait 5-10 minutes before
restarting the machine. Rapid and continued
start-up attempts do nothing but prolong the
period of inactivity of the machine.
•Check that the machine is correctly
positioned with the ventilation grids (6) free
of any obstructions.
•The paddle does not turn:
•Check that the paddle (5) is properly
attached to the tube and locked with a
special locking ring (4).
•Make sure it is free from obstacles that
prevent it from rotating.
•Make sure the lid is closed in the correct
position: a safety device stops the paddle
when the lid is opened.
•The machine is noisy:
•Some noise is part of the normal operating
specifications, but if it becomes excessive
contact the Service Centre to avoid further
and more serious problems.
•The water discharge pipe leaks:
•Replace the gaskets of the water discharge
8
English
tap (9). Two additional gaskets sets (13) are
provided with the machine.
•The plastic sleeve (14) on the lower part of the
paddle is too easy to separate.
•Replace the gasket with the new one. Four
additional gasket (12) are provided with the
machine.
Materials and articles destined for use in
contact with food products are conform to
the EC Regulation 1935/2004. This
appliance complies with the requirements of
the Low Voltage Directive 2006/95/EC, and
the Electromagnetic Compatibility Directive
2004/108/EC.