Control Panel Operation - Hkoenig KB20 Manual De Utilización

CONTROL PANEL OPERATION ：
The indicator of POWER will flash after plugged in, and then the machine enters standby
state. It will start to work by pressing POWER button, accompanying indicator lighting.
During operation, pressing this button, the machine will return to standby state.
This button is for selecting the size of ice. The default setting is large ice, if the small one
is needed, pressing this button is available. When you select the desired size,
corresponding indicator of S (small) or L (large) will be on.
Press and hold "SELECT" button for 3 seconds to activate pipeline self-clean process,
which takes "pump water in for 30 seconds---water tank run to drain out water" as a
circle, and this circle will run for 5 times. Flashing of indicators of "S" and "L" will take
place in turn until self-clean process is over and the machine enters standby mode. Take
away the plastic plug to drain water and then whole process is finished.
When the indicator of this button turns to red, it means insufficient water to water
reservoir, you need to add enough water and press POWER button to restart the
machine.
When the ice reach to the max storage capacity, the indicator of this button will flash,
and the machine will stop working. What you need to do is pouring out the ice, if the
position of ice is lower than the position of ice bin full sensor, the machine will restart
automatically.