Troubleshooting - Hkoenig KB20 Manual De Utilización

2. Keep ventilation openings in the appliance enclosure, or
in the built-in structure, clear of obstruction. Do not use
mechanical devices or other means to accelerate the
defrosting process, other than those recommended by
the manufacturer.
3. Reuse the machine after being idled for a period of time,
it may not have enough water to pump for air retard, and
the indicator of "ADD WATER" will keep lighting. At this
time, you just need to press POWER button again, the
machine can enter normal state.
4. To ensure the cleanness of ice, please change water for
water reservoir at least once one day. If do not use for a
long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water,
fully water or interruption of power supply, it will delay for
3mins to start up after restarted.
6. Always use fresh water before starting ice production
either at initial installation or after a long shut-off period.
TROUBLESHOOTING ：
Please note, if a power failure occurs due to disconnection of the power cord, or the power
1.
button has been pushed off during an ice making cycle, small ice chips may formed and lodge
in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by
disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and
removing the ice chips, then restarting.
Please check if the water reservoir is flat when the ice shovel can not remove the ice to ice basket.
2.
If not, please push the ice shovel gently by finger, then press POWER button to restart.
PROBLEM
The compressor
works abnormally
with a Buzzing
Noise
Water shortage
indicator
light is on
Indicator lights on
display are not on
POSSIBLE CAUSE
The voltage is lower than
recommended
1.There is no water
2.The pump is full of air
Blown fuse/ No power
SUGGESTED SOLUTIONS
Stop the Ice maker and do not restart
until the voltage is normal.
1.Add to some water until it reaches
MAX position
2.Press POWER button to restart
Replace fuse / Turn power on