Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
With +/- buttons you can set desired temperature form 40-100°C in 5°C-steps.
Direct setting to 100°C: Press+ button for 2 seconds or longer
Direct setting to 80°C: Press + and – buttons together for 2 seconds or longer
Direct setting to 60° C: Press – button for 2 seconds or longer
After an acoustic signal the desired temperature is saved.
The desired temperature is displayed for 6 seconds.
Without further operation the device switches to ready mode after 6 seconds.
Press the
button to start the heating process. The button lights up in "red". The
display shows the current temperature in 1°C steps. Below 30°C "- - " is displayed.
When the desired temperature is reached then the device will beep 5 times and switches
to keep warm mode, the button
► If the set temperature is below the water temperature then the light of the
switches off and the device will beep for 3 seconds. Device switches to standby mode.
► When the kettle is on the base then the desired temperature is saved for next
operation.Otherwise the last selected temperature remains saved.
16.3 Keep warm mode
After heating operation the device automatically switches to keep warm mode.
If 95° or 100°C were set then the keep warm temperature is 90°C. Otherwise the keep
warm temperature is the set temperature.
After 60 minutes without further operation the device will beep 5 times and switches to
ready mode, the display is illuminated and buttons are not illuminated anymore.
16.4 Standby mode / reactivation of the device
The device can be reactivated from standby mode, by taking the kettle from the base or by
pressing of any button.
16.5 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.
lights up in „orange".
Please note
-button
31
Publicidad
Tabla de contenido
