Troubleshooting; Disposal Of The Old Device - CASO DESIGN WK Cool-Touch Instrucciones De Funcionamiento Originales

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
Problem
The device switches off
before boiling or before it
has reached desired
temperature.
The device does not switch
off.
The device cannot be
switched on.
The device is not reaction
on pressing of buttons / the
display shows nothing
Errorcode E1

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they could be
detrimental to human health and the environment. Therefore, do not put your old device
into the non-recyclable waste under any circumstances.
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►
Attention
Cause
Too much scale in the
kettle.
The lid is not closed
correctly.
The device has not cooled
down sufficiently.
The overheat protection is
activated, for example
because of not enough
water in the kettle
Short circuit
Please note
Solution
Descale the device.
Close the lid correctly. .
Allow the device to cool down.
Take the kettle from the base
and let it cool down at least
20 minutes.
After that you can fill in water
again and operate the device.
Contact the customer service.
33