Hansgrohe Talis S 32020000 Instrucciones De Instalación página 8

Assembly
Attention! The fitting must be installed,
flushed and tested after the valid norms.
1. Flush through the supply pipes..
2. Place the mixer including the sealing washer
in position on the basin / bidet.
3. Slip the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation val-
ves;
cold right - hot left.
5. 32020000/32022000/32034000/
32220000/32222000:
Connect the pull rod to the pop-up waste.
The hot and cold water supply's should be of
equal pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with water-
dimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
8
English
Hansgrohe single lever mixers can be used toget-
her with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous water heater causes any pro-
blems or there is not enough flow of water, the
waterdimmer (7a) located behind the aerator must
be removed.
To adjust the hot water limiter on single lever
mixers, please see page 16.
No adjustment is necessary when using a conti-
nuous flow water heater.
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10
11
7 l/min 3 bars
14 l/min 3 bars
Special accessories
max. 10 bars
X
1 - 5 bars
(not part of delivery)
16 bars
max. 80° C
65° C
handle
handle
flange
nut
cartridge cpl.
locking screw for handle
aerator
pop up rod
fixing set
connection hose 450 mm
connection hose 450 mm
special tool set
32092000
96338000
32094000
96656000
96690000
92730000
96059000
13912000
96657000
96016000
95001000
97206000
58085000