Hansgrohe Talis S 32020000 Instrucciones De Instalación página 8

Assembly
Attention! The fitting must be installed, flushed
and tested after the valid norms.
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation
valves; cold right - hot left.
5. 32020000/32022000/32024000/
32034000/32220000/32222000:
Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal pres-
sures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with water-
dimmer (flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 0,3 MPa
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Test certificate:
32020000/32034000/
32031000:
Hansgrohe single lever mixers can be used
together with hydraulically and thermically control-
led continuous flow heaters if the flow pressure is
at least 0,15 MPa.

English
7 l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
65° C
WRAS
If the continuous water heater causes any problems
or there is not enough flow of water, the water-
dimmer (7a) located behind the aerator must be
removed.
To adjust the hot water limiter on single lever mix-
ers, please see page 19.
No adjustment is necessary when using a continu-
ous flow water heater.
Spare parts (see page 3)
1 handle
1.1 screw cover
2 handle
3 flange
4 nut
5 cartridge cpl.
6 locking screw for handle
7 aerator
8 pop up rod
9 fixing set
10 connection hose 450 mm
11 connection hose 450 mm 3/8" 97206000
Special accessories
X special tool set
(order as an extra)
32092000
96338000
32094000
96656000
96690000
92730000
96059000
13912000
96657000
96016000
95001000
58085000