Publicidad
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1
Flush through the supply pipes.
2
Place the mixer including the sealing
washer in position on the basin.
3
Slip the slide washer, washer and collar nut
over the threaded base and tighten the
collar nut by hand.
4
Tighten screws.
5
Connect the supply pipes to the isolation
valves; cold right - hot left.
6
Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with
waterdimmer® (flow limiter).
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Test certificate
DVGW
14020XXX
31022000
4
English
7 l/min 0,3 MPa
14 l/min 0,3 MPa
max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
P-IX
SVGW
P-IX
X
9950/IA
P-IX
X
9950/IA
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
If the continuous water heater causes any
problems or there is not enough flow of water,
the waterdimmer® (6a) located behind the
aerator must be removed.
To adjust the hot water limiter on single lever
mixers, please see page 5.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 3
1
handle Metropol S
2
screw cover
3
flange
4
nut
5
cartridge cpl.
6
seal
7
aerator cpl.
8
fixing set
9
connection hose
10
pull rod
11
lever arm cpl. 340 mm
12
handle Metris S
Special accessories
X special tool set 58085000
(order as an extra)
XXX = Colors
000 chrome plated
880 satin chrome
ACS
NF
X
X
14895XXX
96338000
97406XXX
97209000
92730000
95008000
13912XXX
13961000
96316000
96657XXX
96324000
31093000
WRAS
KIWA
X
X
Publicidad
