SOMFY Maestria WT Manual De Instrucciones página 47

E3. END LIMIT AUTOMATIC SETTINGS
When specific driven product is equipped with a heavy load bar
and a top stop, end limits set automatically a er following next
step below:
Press the "Up" and "Down" buttons simultaneously until
1)
the driven product moves up and down briefly.
Press the "Up" button until the driven product moves up and
2)
down briefly.
Press the "Up" and "Down" buttons simultaneously until
3)
the driven product moves up and down briefly.
Place the driven product at its half-way position
4)
Press and hold the "Down" button: the driven product
5)
lowers until it detects the lower end limit.
Press the "Up" and "Down" buttons simultaneously until
6)
the driven product moves up and down briefly to validate
the setting.
If the lower end limit is not set automatically a er several attempts, perform the step E2.
2. 3. 3. Setting advanced functions
Set the advanced functions a er having performed the end limits setting (§2.3.2).
Use universal adjusting cable 9015971 (follow the instructions in the corresponding manual for
connection), or use a non-locking double push-button switch to adjust settings.
"BACK RELEASE" FUNCTION FOR DRIVEN PRODUCTS WITH TOP STOP ONLY
This function releases tension on the fabric a er the driven product is closed at the top stop against
the head rail.
The Back Release function is deactivated by default.
To activate or deactivate the
-
Place the driven product at its upper end limit.
1)
Press the "Up" and "Down" buttons simultaneously until the
2)
driven product moves.
If the "Back release" function was deactivated, it is now activated.
•
If the "Back release" function was activated, it is now deactivated.
•
In order to check the "Back release" function, position the driven product at its half-way position,
-
then press "Up" to raise the driven product to the top stop.
Copyright © 2016 Somfy SAS. All rights reserved.
function:
1)
3s
3)
3s
5)
1)
Images not contractually binding
EN
2)
3s
4)
6)
2)
3s
47