WAGNER ON-DEMAND 915 POWER STEAMER Manual Del Usario página 5

Usage
Before you begin:
Start
DO NOT leave steam plate
unattended, or face down on any
surfaces.
DO NOT operate the steamer once
the water container is empty. make
sure to wear gloves and eye
protection.
Before unscrewing the filler cap
and filling the reservoir, make sure
any remaining water has cooled for
at least twenty (20) minutes. Empty
any remaining water to avoid
over-filling.
Do not look directly down into the
fill hole when filling. Keep your
free hand and others at a safe
distance.
The spray handle may become
warm to the touch during usage.
Note: Before using, trigger the spray handle
into a sink or empty bucket to purge any
remaining cold water.
Using the trigger
1
Cooling / refilling
1
Off
1. Shut the unit OFF.
Activate trigger until all pressure
has been released.
Wallpaper removal
1
1. For best results, use a scoring tool or a putty
knife (sold separately) and gently score
the wallpaper in a crisscross pattern before
removal. The perforations will allow the steam
to penetrate the wallpaper.
5
1. You can control the flow of steam from the
accessory by activating the trigger.
The trigger will also relieve any built-up
pressure remaining in the system after the
steamer has been shut off.
Note: Just turning the power OFF does not relieve
steam pressure. During cool down, treat the unit as if
it is under pressure. Always activate the trigger before
removing the fill cap.
2
20 minuteS
2. Unplug power cord.
Allow steamer to cool for at least
twenty (20) minutes.
* See NOTE, above.
2
15-20 SEC.
2. To remove wallpaper, hold the steam plate flat against the
scored wallpaper. Pull the trigger and hold for 15-20 seconds.
Move the steam plate to a new section and remove the
steamed section with a scraper blade (sold separately).
3
3. Once unit has sufficiently cooled,
repeat steps 4-6 in setup to
continue.
English