Installation; Installing The Imprinter - Fujitsu fi-565PR Guia Del Usuario

2. Installation

2.1. Installing the Imprinter

Install the imprinter as follows:
1. Switch off the Scanner and disconnect the
electrical power cable.
2. Remove the Stacker from the scanner.
Lift the Stacker about 45°.
At the end of the Stacker, where attached to the scanner,
press down on the lower center of the Stacker to release it
and gently pull the Stacker away.
3. Remove the cover (black) located under the
stacker.
You must remove the stacker and black cover
ATTENTION
before installing the Imprinter to the Scanner.
4. Install the Imprinter to the Scanner.
Check the insertion direction of the Attachment Guide.
Attachment Guide
Check the Shaft from below.
ADF
Scanner
Locate the Attachment Guide along the Shaft.
Push up the Attachment Guide.
fi-565PR Imprinter Operator's Guide | 5
ADF
Shaft
Shaft