Care And Cleaning - DeLonghi DTT720 Instrucciones Para El Uso

HINTS ON USING YOUR TOASTER
- Select a lower setting for light browning, for toasting one slice only or for dry bread.
- When toasting a single slice of bread, you may notice a variation in toast color from one
side to the other - this is normal.
- Dry/stale bread toasts more quickly than fresh bread and thinly sliced bread toasts more
quickly than thickly sliced bread. Therefore the browning control should be set at a lower
setting than usual.
- For best results ensure that the bread slices are of an even thickness, freshness and size.
- In order to achieve uniform browning we recommend you wait a minimum of 30 seconds
between each toasting so that the control can automatically reset. Alternatively select a
lower setting when additional toasting is carried out.
WARMING RACK SAFETY
1 Never completely cover the warming rack.
2 When using the warming rack, never wrap the food up. Plastic wrapping will melt and
could catch fire. Foil will reflect heat, damaging the toaster.
3 If you're using the toaster slots, always remove the warming rack so it can't burn you.
TO USE THE WARMING RACK
1 Place the warming rack into the holes on top of the toaster
(Fig.1).
2 Put your food on top of the rack (slice thick items in half to
keep their outsides from burning). Watch to make sure it
doesn't burn, and turn it over half way through.
3 Press the warming rack button, then press the carriage but-
ton. Both buttons will glow and the carriage will lower
automatically.
4 During operation the indicator lights will flash one after the
other and after about 2 1/2 minutes the carriage will rise
automatically.
5 To stop the operation at any time press the carriage button.
6 To remove the warming rack, allow the toaster to cool and
unplug.
7 Lift off the warming rack.
TO STOP THE AUDIBLE BEEP
Should you wish to stop the audible beep that accompanies some of the toaster operations,
hold down the defrost button for 3 seconds and the defrost light will go out to acknowledge the
change.
If at any point you wish to re-install the beep repeat the
above procedure and the toaster will beep once. However,
when the toaster is unplugged the beep will automatically be
re-installed.

CARE AND CLEANING

1 Before cleaning, unplug your toaster and let it cool down.
2 Slide out the crumb tray (Fig.2). Clean, then replace. Do
this regularly: crumbs can smoke or even burn.
3 Wipe the outside of the toaster with a damp cloth, then
dry.
Fig.2
Fig.1
5