BR20 - BR30 model
6.4. CHECK-WEIGHING
6.4.1. About check-weighing
Check-weighing is a procedure to cause an alarm to sound when the weight on the meets or exceeds values
stored in memory. The memory hols values for a high limit and a low limit.
Check mode OK (good):
When check range, the display will show OK and the beeper will sound when the weight is between the
limits.
Check mode NG (no good):
When check range, the display will show OK and the beeper will sound when the weight is out of the li-
mits.
6.4.2. Set limits
Press
and
to enter, use
and
value. A er you enter the value, press
6.4.3. Set check weighing mode
Press
and
press
key to select
press
key to escape.
6.4.4. Note
Checkweighing func on only available when weight more than 20d(min).
To disable the Check-Weighing func on enter zero into both limits by pressing the
rrent limits are shown then pressing ZERO/TARE to store the zero values.
6.5. ACCUMULATE OPERATE
6.5.1. Note
The scale can be set to ccumulate manually by pressing the
tails of selec ng the method using func on
Please note before every accumulate operate, scale need return to zero, and only press
ble, when weight less than 20d, accumulate operate will be invalid.
6.5.2. Accumulate operate
The weight displayed will be stored in memory when the
The display will show
accumulate operate,
be output to a printer or PC.
Remove the weight, allowing the scale to return to zero and put a second weight on. Press
ACC 2
display will show
Con nue un l all weights have been added.
6.5.3. Memory recall
The view the totals in memory press
6.5.4. Memory clear
To clear the memory, just press
key together, it will display
key to move ac ve digit, use
key together, it will display
ok
(check mode OK),
ACC1
and then the total in memory for 2 seconds before returning to normal (a er do
indicator will turn on). If the op onal RS232 interface is installed the weight will
and then the new total.
key.
and
SEt
H, use
key to select
key to change value, use
key to sure, press
key to escape.
SEt
H, use
key to select
nG
(check mode NG),
key. See the PARAMETERS Sec on for de-
P2
Coñ.
key is pressed and weight is stable.
together.
SEt H
SEt
L, press
or
bEEP
, press
no
(no beep), press
key when the cu-
User's Guide
key
key to clear
key to enter,
key to sure,
key when sta-
key, the
25