Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BR20 - BR30 model
For example when the display shows
This display will show
SEt H i
parameter,
for se ng the high limit.
A er pressing the
the
key to increment the flashing digit. Con nue to the next digit and set it as needed.
When all digits have been set press the
SEt
Lo. Advanced to another prameter if needed or press the
just st, i.e.
Parameter se ng table
FUNCTION SUBFUNCTION DESCRIPTION
PO CHk
SEt H
SEt Lo
P1 Coñ
PtYPE
P2 CAL
CoUnt
P3 otH
The weighing indicator can be operated from the ba ery if desired. The ba ery life is approsimately 50
hours.
When the ba ery needs charging a symbol on the weight display will turn on. The ba ery should be char-
ged when the symbol is on. The scale will s ll operate for about 10 hours a er which it will automa cally
switch off to protect the ba ery.
To charge the ba ery simply plug into the mains power. The scale does not need to be turned on.
PO CHk
SEt
Lo, press the
key to set a limit, use the
Set high limit, press
value, press
Set high limit, press
value, press
Set beep mode:
no: no beep for check Weighing
bEEP
ok: beep when weight between hi and low (OK)
nG: beep when weight out of hi-low range (NG)
This op on is used to set RS232 communica on mode. Op ons:
ñodE
Cont
(con nuously send)
St1: Send one frame data a er stable.
StC: Send data con nuously when stable.
Pr1: When press print key, send one frame data (printer mode).
Pr2: When press M+ key, do print data and M+ at the same me.
Auto: Auto accumulate (auto print) mode, when weight stable and then return
to zero, indicator will do accumulate and print operate automa cally.
ASk: Ask mode, bi-direc on.
Command R; read data.
Command T; tare.
Command Z; zero.
bAUd
This op on is used to set baud rate. Op ons: 600 / 1200 / 2400 / 4800 / 9600
Pr
This op on is used to set parity verify. Op ons: 7E1 / 701 / 8N1
tPUP: For mini printers.
LP50: For labellers.
This display will show xxxxxx for indica ng the internal counts.
dEC i
This op on is used to select the decimal. Op ons: 0, 0.0, 0.00, 0.000.
This op on is used to select the dual division.
dUAL
Then you could set the division and capacity of the Range 1 and Range 2.
CAL
Calibrate.
LoCk
Enable / disable key lock.
Anñ
ON (animal); OFF (normal mode)
press the
key to begin.
key to set the low limit, or press the
and
keys to change the flashing digit, then use
key to store the value. The display will go back to the parameter
and
key to move ac ve digit, press
key to clear data, press
and
key to move ac ve digit, press
key to clear data, press
to skip to the next
key to return to weighing.
key to sure.
key to sure.
8. BATTERY OPERATION
User's Guide
to change
to change
27
Publicidad
Tabla de contenido
