Craftsman 139.53960SRT Manual Del Propietário página 22

INSTALLING THE BRACKETS
Be sure power to the opener is disconnected.
Install and align the brackets so the sensors will face
each other across the garage door, with the beam no
higher than 6" above the floor.They may be installed
in one of three ways, as follows.
Garage door track installation (preferred):
• Slip the curved arms over the rounded edge of
each door track, with the curved arms facing the
door. Snap into place against the side of the track.
it should lie flush, with the lip huggingthe back
edge of the track, as shown in Figure 1.
If your door track wilt not supportthe bracket
securely, wall installationis recommended.
Wall installation:
• Place the bracket against the wall with curved arms
facing the door. Be sure there is enough clearance
for the sensor beam to be unobstructed.
• if additional depth is needed, an extension bracket
(see Accessories) or wood blocks can be used.
• Use bracket mounting holes as a template to locate
and drill (2) 3/16" diameter pilot holes on the wall at
each side of the door, no higher than 6" above the
floor.
• Attach brackets to wall with lag screws
(not provided).
• If using extension brackets or wood blocks, adjust
right and left assemblies to the same distance out
from the mounting surface. Make sure all door
hardware obstructions are cleared.
Floor installation:
• Use wood blocks or extension brackets (see
Accessories) to elevate sensor brackets so the
lenses will be no higher than 6" above the floor.
• Carefully measure and place right and left
assemblies at the same distance out from the wall.
Be sure all door hardware obstructions are cleared.
• Fasten to the floor with concrete anchors as shown,
HARDWARE SHOWN ACTUAL SIZE
Carriage Bolt Wing Nut Staples
1/4"-20x1/2" 1/4"o20
Figure 1
DOOR TRACK MOUNT (RIGHT SLOE)
Door
Track
_ensor
Bracket
indicator
Light
Figure 2
(Provided with
Extension --
Bracket) _"
WALL MOUNT (RIGHT SIDE)
Extension
Bracket
(See Accessories)
(Provided with
Extension Bracket)
Sensor
Bracket
Indicator
Lens Light
Figure 3
Lens
Sensor
Bracket
FLOOR MOUNT (RIGHT SIDE)
Indicator
Light
(Provided with
"*' Extension Sracket)
Attach with
Concrete Anchors
not provided)
, i**e°sie°
] Bracket
See Accessones)
t i
Q
22