Programming; Hand.held Remote Control; To Erase All Codes; 3-Function Remotes - Craftsman 139.53960SRT Manual Del Propietário

PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional "SRT" remote controls.
To Add an Additional Hand.held Remote Control
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
[]
2. Within 30 seconds, press and
hold the button on the hand-held
remote* that you wish to operate
your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs are
not installed, two clicks will be
heard.
\1/
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, I_
first erase all codes:
Press and the hold "learn" button on
motor unit until the learn indicator
light goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or
keyless entry you wish to use.
*3.Function Remotes
If supplied with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any "SRT"
3-function remote or ___ ..7_
compact remote can be
programmed to operate
other "SRT" garage door
openers.
35