Craftsman 139.53960SRT Manual Del Propietário página 36

To Add or Change a Keyless Entry PIN
Note: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on motor unit. The learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, enter a four
digit personal identification
number (PIN) of your choice on
the keypad. Then press and hold
the ENTER button.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
\1 /
To change the code in your Keyless
Entry at any time, repeat Steps 1-3.
To ensure that your hand-held
remote control codes were not
disturbed while you were
programming the Keyless Entry, test
your remotes and reprogram them if
necessary.
36