Weston PRO Serie Manual De Instrucciones página 12

HIGH-SPEED STUFFER
ASSEMBLY INSTRUCTIONS
WARNING!
Before cleaning, assembling or disassembling the
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
NOTE: The High-Speed Stuffi ng System
is designed for use with the 10 mm Funnel
ONLY. DO NOT attempt to use the High-
Speed Plastic Auger with any other Funnels.
SERIOUS DAMAGE to the Grinder Head
and other components may occur. Follow
the "Standard Stuffer Assembly Instructions"
located in this manual, when using the 20, 30,
or 40 mm Funnels.
1. Insert the Head into the Gear Housing
with the feed chute of the Head facing straight
up. You will need to line up the slot in the
Head with the Pin inside the Gear Housing.
Be sure the Head is seated fully into the Gear
Housing .
(Figure 8)
2. Tighten the Head Locking Knob to
lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
Align the Auger Splines with the Drive
Shaft of the Grinder.
NOTE: Periodically inspect the
Auger Bearing for wear.
Auger Bearing is worn excessively,
replace it immediately or Head
damage could result.
4. Slide the High Speed Plastic
Auger onto the Auger Pin making
sure the square part of the Plastic
Auger fully seats on to the square
portion of the Auger Pin.
5. Slide the 10 mm Stuffi ng
Funnel through the through the
Flange and place it through the
Front Ring Nut.
6. Install the Front Ring Nut,
DO NOT OVERTIGHTEN.
the Front Ring Nut until it makes
contact with the Flange, then
make 1/4 turn more to tighten into
place.
Feed
Chute
Head
Auger
.
(Figure 9)
Auger Pin
If the
Flange
Front Ring
Nut
Turn
-12- -12-
FIGURE 8
Slot in Head
Gear
Housing
Head Locking
Knob
FIGURE 9
Head
Auger Bearing
Auger Splines
High-Speed
Plastic Auger