Weston PRO Serie Manual De Instrucciones página 17

SAFETY GUARD INSTRUCTIONS
(Only equipped on#22 & #32 Grinders)
WARNING!
Before cleaning, assembling or disassembling the
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
The #22 and #32 Grinders are
equipped with a Safety Guard. This
Safety Guard is here to prevent injury
to the user. The only reason that the
Safety Guard should be removed is
for cleaning purposes, then it should be
IMMEDIATELY REPLACED.
To remove the Safety Guard, use the
provided Flat-head Screwdriver to
loosen all four of the screws that hold
the Safety Guard to the Tray
There is no need to completely remove
the screws from the Safety Guard, as
they can be easily lost.
Remove the Safety Guard, clean as
instructed in the "Cleaning Instructions"
then IMMEDIATELY REPLACE
the Safety Guard onto the Tray.
Safety
Guard
.
(Figure 14)
WARNING!
NEVER operate Grinder without the
Tray/Safety Guard secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.
-17-
FIGURE 14