Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE SENSOR
1
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole: Reset unit to default settings
5. CHANNEL button: Select channel 1
GETTING STARTED
POWER SUPPLY
Batteries serve as a back-up power supply. For
continuous use of projector and backlight, install
adapter. The socket-outlet shall be installed near the
equipment and shall be easily accessible.
NOTE
will appear when power supply is not
connected.
2
4
3
5
To insert batteries:
1. Remove the battery compar tment and inser t
batteries, matching polarities.
2. Press RESET after each battery change.
LOCATION
Clock / alarm area
Outdoor / indoor
temperature area
REMOTE SENSOR
To set up the sensor:
1. Open the battery compartment, and insert batteries,
matching polarities.
2. Place the sensor within 30 m (98 ft) of the main
unit using the table stand or wall mount.
The transmission range may vary depending on many
factors. You may need to experiment with various
locations to get the best results.
3
MEANING
Main unit batteries low
Sensor batteries low
Publicidad
Capítulos
