switch is triggered, the keypad will send a Tamper report to the control panel
via the communication bus.
Option [8] OFF = Grafica's tamper option is disabled (default)
Option [8] ON = Grafica's tamper option is enabled
4.8 Beep on Trouble
S
[003]: O
ECTION
Potential troubles have been sorted into groups. With these options enabled,
the keypad will emit an intermittent beep tone whenever a trouble condition
occurs from one of the trouble groups. The intermittent beep will remain
activated until the user enters Grafica's Trouble Display or if the trouble is
resolved. For a list of troubles, see the appropriate control panel's Reference
and Installation Manual. The intermittent beep will be re-initialized whenever
the trouble condition reoccurs.
4.8.1 System and Clock Trouble Beep
S
[003]: O
ECTION
Option [1] OFF = Beep disabled (default)
Option [1] ON= Beep on: System Troubles and Clock Loss
4.8.2 Communicator Trouble Beep
S
[003]: O
ECTION
Option [2] OFF = Beep disabled (default)
Option [2] ON = Beep on: Communicator Troubles
4.8.3 Module and Bus Trouble Beep
S
[003]: O
ECTION
Option [3] OFF = Beep disabled (default)
Option [3] ON = Beep on: Module and Bus Troubles
4.8.4 All Zone Trouble Beep
S
[003]: O
ECTION
Option [4] OFF = Beep disabled (default)
Option [4] ON = Beep on: All Zone Troubles
4.9 Confidential Mode Timer
S
[004]
ECTION
Section [004] determines the amount of time that must elapse without
performing an action on the keypad before the keypad enters Confidential
Mode (Section 4.5 on page 7). The Confidential Mode Timer can be any
value from 005 to 255 seconds (default: 120 seconds).
8 Reference & Installation Manual
[1]
[4]
PTIONS
TO
[1]
PTION
[2]
PTION
[3]
PTION
[4]
PTION