Configuring The Watchdog; Configuring The Record Mode; Configuring The File Format - Blackmagic Design Duplicator 4K Manual De Instalación Y Funcionamiento

Querying and updating configuration information
The "configuration" command may be used to query the current configuration of the deck:
configuration
The server returns the configuration of the deck:
211 configuration:
video input: {"SDI", "optical"}
↵
One or more configuration parameters may be specified to change the configuration of the deck.
To change the current video input:
configuration: video input: {"SDI", "optical"}

Configuring the watchdog

The "watchdog" command instructs the deck to monitor the connected client and terminate the connection
if the client is inactive for at least a specified period of time.
To configure the watchdog:
watchdog: period: {period in seconds}
To avoid disconnection, the client must send a command to the server at least every {period} seconds. Note
that if the period is set to 0 or less than 0, connection monitoring will be disabled.

Configuring the record mode

Use the 'record mode' command to select the deck recording mode:
configuration: record mode: {"Duplicate", "SingleDisk", "DiskOverwrite"}

Configuring the file format

The 'file format' command instructs the deck to switch to a specific file format for codec and bit rate:
configuration: file format: {"H.264High", "H.264Medium", "H.264Low",
"H.265High", "H.265Medium", "H.265Low"}
↵
↵
↵
↵
↵
↵
Remote Control via Ethernet
↵
34