Care And Cleaning; Troubleshooting - IKEA LAGAN Manual De Usuario

ENGLISH

Care and Cleaning

Warning! Refer to Safety chapters.
General warnings
Caution! Unplug the appliance before
carrying out any
This appliance contains hydrocarbons
in its cooling unit; maintenance and
recharging must therefore only be
carried out by authorized technicians.
The accessories and parts of the
appliance are not suitable for washing in
a dishwasher.
Cleaning the interior
Before using the appliance for the first time,
the interior and all internal accessories should
be washed with lukewarm water and some
neutral soap to remove the typical smell of a
brand-new product, then dried thoroughly.
Caution! Do not use detergents or
abrasive powders, as these will damage
the finish.
Initial power on
Caution! Before inserting the power
plug in to the outlet and switching on
the cabinet for the first time, leave the
Trouble Shooting
Warning! Refer to Safety chapters.
What to do if...
Problem
The appliance does
not operate.
The appliance is
noisy.
Possible Cause
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
appliance standing upright for at least
4 hours. This will assure a sufficient
amount of time for the oil to return
to the compressor. Otherwise the
compressor or electronic components
may sustain damage.
Periodic cleaning
Caution! Do not pull, move or damage
any pipes and/or cables inside the
cabinet.
Caution! Take care of not to damage the
cooling system.
Caution! When moving the cabinet, lift it
by the front edge to avoid scratching the
floor.
The equipment has to be cleaned regularly:
1. Clean the inside and accessories with
lukewarm water and some neutral soap.
2. Regularly check the door seals and wipe
clean to ensure they are clean and free
from debris.
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser and the
compressor at the back of the appliance
with a brush. This operation will improve
the performance of the appliance and save
electricity consumption.
Solution
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket. Contact a qualified
electrician.
Check if the appliance stands
stable.
11