Minka Aire Artemis F803 Instrucciones De Seguridad página 11

NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse
at fuse box.
1. Remove the 3 screws from the mounting plate.
2. Raise and hold the light plate close to the mounting plate and proceed to do the wire connections. Connect the
white wire connectors from the light plate and fan, follow the same procedure with the black wire connectors.
3. Install and secure the light plate by tightening the 3 screws previously removed.
Fig. 13
INSTALLING THE LIGHT BULB AND GLASSE SHADE
WARNING: Shut off the power supply before removing or replacing lamp. In handling of halogen bulb, care should
be taken not to touch it with your bare hands. Oil residue will shorten the life of the halogen bulb. If you accidentally
come into contact, wipe thoroughly with a clean, lint-free, cotton cloth. Allow the bulb to cool off for 10 minutes
before changing the bulb. Use light bulb in accordance with the fan's specification.
TO REDUCE THE RISK OF FIRE DO NOT EXCEED MAXIMUM WATTAGE RATING.
Install 80W R7S halogen bulb (included). (Disregard this step if using the optional switch cup cover) Raise glass
shade or optional switch cup cover up against bottom of fan housing and secure it to fan by turning it clockwise until
snug. DO NOT OVERTIGHTEN.
Note: If installing the optional switch cup cover, make sure is securely tightened.
INSTALLING THE LIGHT PLATE
11
Fig. 14