Finishing The Installation - Minka Aire Artemis F803 Instrucciones De Seguridad

Carefully tuck the wire connections inside the outlet box or wall cavity if not
provided to secure the wall switch and wall plate to the outlet box or wall switch frame.
Fig. 9
Note: Outlet box is not included, and can be supplied separately by the Electrician.
1. Remove the 1 of 2 screws from the bottom of the hanger bracket and loosen the other one a half turn from the
screw head.
2. Slide the canopy up to hanger bracket and place the key hole on the canopy over the screw on the hanger
bracket, turn canopy until it locks in place at the narrow section of the key holes.
3. Align the circular hole on canopy with the remaining hole on the hanger bracket, secure by tightening the two
set screws.
NOTE: Adjust the canopy screws as necessary until the canopy and canopy cover are snug.
Fig. 10

FINISHING THE INSTALLATION

9
using an outlet box. Use the screws