Defrosting Instructions - Danby CONTEMPORARY CLASSIC DAR110A2LDB Manual Del Usuario

OPERATING INSTRUCTIONS
DEFROSTING INSTRUCTIONS:
This refrigerator includes a cycle defrost system. The refrigerator has a cold plate located in behind the back
wall of the refrigerator cabinet. Ice build-up on the back wall during compressor operation is normal. When
the compressor has cycled off, accumulated ice will defrost automatically. Defrost water will collect inside the
drain trough, pass through the drain outlet located at the bottom of the cabinet, and funnel into a drain pan sit-
uated above the compressor. The water will then evaporate from the heat of the compressor.
REMINDER: Keep the drain outlet opening clear of any food particles or other impediments. This will
ensure the water can funnel to the drain pan without obstruction. Failure to keep this drain clean may result in
water overflowing the trough, causing water to accumulate at the bottom of the refrigerator, eventually leaking
onto your floor. Please wipe this trough and drain outlet with a soft cloth as required.
DOOR REVERSAL INSTRUCTIONS:
CAUTION: To avoid personal injury to yourself and/or property, we recommend someone assist you
during the door reversal process.
1. To remove 4 screws from the worktop, remove the 4 screw plugs (C) then unscrew the screws, take off the
worktop (B), move the worktop cover (A) to the opposite side. (Fig. 1)
2. Take out one left/right door strip cover (inside accessory bag), loosen the 4 screws which were fixed to the
upper hinge. Remove the left/right upper hinge, then loosen door spindle (D), remove the door. (Fig. 2)
3. Twist door spindle (D) to the other upper hinge, using the 4 screws to attach it to the other side of the cabi-
net; then install left/right door strip cover (F) to the other side of the door. (Fig. 3)
4. Remove the adjustable foot (G) and the 4 screws on the bottom hinge, move them to the other side of the
unit. (Fig. 4)
5. Adjust the space between upper and bottom hinge by twisting both hinges' screws. Then reinstall the work-
top, and replace the screw plugs (B and C).
4