Descargar Imprimir esta página

Cequent Performance Products Reese Elite Instrucciones De Instalación página 4

Ocultar thumbs Ver también para Reese Elite:

Publicidad

Idiomas disponibles

Idiomas disponibles

7.
Hitch height determination:
With trailer leveled and on level ground measure from the ground to the coupler, Dimension "A" in Fig. 6.
Secondly, measure from the height of the inside of the truck bed to the ground, Dimension "B" in Fig. 6.
Dimensions "C" and "D" in Fig. 6 can be used to determine the amount of clearance over the side rails, as
mentioned in instruction #6 (Additional clearance may be needed for off road maneuvering and/or steep
inclines while turning).
The 2" value is an estimate of suspension compression due to king pin weight of the trailer. This
compression could range between 1"-5" depending on the truck being used and the trailer being towed.
Connection for trailer wiring must be located at the side of the truck bed between the driver's
seat and the rear wheel to prevent operators from working between the truck and trailer.
Avoid putting any part of your body under the trailer or between the truck and trailer.
Unexpected or accidental movement of the truck or the trailer can cause serious injury or death
If you must place any part of your body under the trailer or between the truck and trailer you
MUST perform ALL of the following steps:
Check that the truck transmission is in park
Check that the emergency brake is on
Block in front of and behind all trailer tires
Check that the trailer landing gear are resting on firm ground
30127IN – 9/10/10 REV C
Hitch Height = A – B + 2"
D – C + 2" > 6" as noted in instruction #6.
B
C
PCN14106
D
A
FIG. 6
WARNING:
©2010 CEQUENT PERFORMANCE PRODUCTS, INC.
*MEASURED WITH TRAILER LEVEL,
ON LEVEL GROUND
4
Printed in CHINA

Publicidad

loading