Publicidad
Idiomas disponibles
Idiomas disponibles
REESE™ Elite Series
TOOLS
Safety Glasses
Impact Wrench
1-1/8" Box or End Wrenches or socket
1.
Check all the boxes for all the components listed in
2.
Locate the "dimple" in the depression in the middle of the truck bed. Using the 3 ½" hole saw, cut a hole in the
location shown in Figure 7 below. If there are no dimples in your bed, measure from the rear of the bed forward
46-3/8". Find the center of the bed by measuring between the fender wells or a weld seam that is visible on both
sides of the bed. Drill a 3-1/2" hole at this location.
Vehicle Front
30127IN – 9/10/10 REV C
GOOSENECK ASSEMBLY
PCN14106
©2010 CEQUENT PERFORMANCE PRODUCTS, INC.
3 ½" Hole Saw
Torque Wrench
Figure 1
and become familiar with component terminology.
Drill 3 ½" hole in this location
Fig. 8
Fig 7
5
Printed in CHINA
Publicidad
