• The console that is fitted on the handlebar is not
waterproof. Take care not to sweat over the console,
as the sweat could damage the electronic circuit.
• Do not keep the RealAxiom Wireless in wet or
damp places. This could damage the electronic
components.
ADVICE:
• For less tyre wear and better grip on the roller,
it is advisable to use tyres of 23 mm width.
• Recommended rear wheel pressure: 7 -8
atmospheres for racing tyres; 3.5 - 4 atmosphe-
res for MTB tyres. For particular cases, comply
with the pressure recommended by the tyre
manufacturer.
• For quieter use, better grip of the tyre on the
roller and reduced vibration, use slick tyres (also
for Mountain bikes).
• Before use, clean the tyre with alcohol or
water.
INFORMATION ON PRODUCT DISPOSAL
1) WITHIN THE EUROPEAN UNION
This product conforms with European Directives 2002/95/CE, 2002/96/
CE and 2003/108/CE
The crossed bin symbol given on the equipment or on the packaging indicates that at the end of its
service life the product must be collected separately from other waste.
Therefore at the end of its useful life the user must take the equipment to an appropriate centre for
the differentiated collection of electronic and electrotechnical waste, or return it to the dealer when
purchasing a new product of equivalent type.
Adequate differentiated collection for subsequent sending of the scrapped equipment to recycling,
treatment and environmentally-friendly disposal can help prevent possible negative consequences for
the environment and the health of people and favours the reuse and/or recycling of the materials from
which the equipment is made.
Improper disposal of the product by the user could involve penalties as specified by the regulations
in force.
2) IN NON-EU COUNTRIES
If you want to dispose of this product, please contact your local authorities and ask them what disposal
method applies.
• Never exceed the MIN level of the Ritmo foot
regulator.
• The conformity of the RealAxiom Wireless to the
Council Directives (ref. "Declaration of Conformity"
at page 100) could be compromised if not used with
the supplied power adaptor (ref. U).
• If the pin of the quick release supplied protrudes
more than 3 mm from the fixing nut, cut off the
protruding part (fig. 43).
.
EN
43
37