Publicidad
Idiomas disponibles
Idiomas disponibles
4
INSTALL SHIELD AND GEAR HOUSING ASSEMBLY
1. Install the gear housing and shield assembly.
2. Align the gear housing on the drive shaft and install the locating
screw (N).
3. Tighten the two (2) side clamping screws (M).
Balance Unit
1. Put on harness and attach unit to harness.
2. Slide harness clamp up and down until unit balances with
head approximately 2 - 3 in. from the ground.
3. Tighten clamp bolt.
NOTE
In case of Emergency, the trimmer/brushcutter can be released from
the harness by pulling up on the quick-release collar.
ECHO CONSUMER PRODUCT SUPPORT: If you require assistance
or have questions concerning the application, operation or maintenance
of this product you may call the ECHO Consumer Product Support
Department at 1-800-673-1558 from 8:30 am to 4:40 pm (Central Standard
Time) Monday through Friday. Before calling, please know the model
and serial number of your unit to help your Consumer Product Support
Representative.
ECHO, INCORPORATED
400 OAKWOOD ROAD
LAKE ZURICH, IL 60047 U.S.A.
www.echo-usa.com
B
2 - 3"
A
A
Publicidad
