Setting Up Your Cd Boombox; Connecting To Ac Power; Installing The Batteries - Insignia NS-B1110 Guia Del Usuario

NS-B1110.fm Page 4 Friday, February 24, 2006 12:10 AM

Setting up your CD boombox

Connecting to AC power

Always use AC power whenever possible to conserve the battery
charge. When your CD boombox is connect to AC power, it does not
use the batteries.
To connect AC power:
1 Make sure that the type of power in your area matching the type of
power listed on the label on the back of your CD boombox. If the
power type does not match, contact your retailer or Insignia.
2 Unwind the AC power cord.
3 Plug the small end of the AC power cord into the AC power
connector on the back of your CD boombox.
4 Plug the other end of the AC power cord into a power outlet.
Note Unplug the AC power cord if you will not be using your CD
boombox for an extend period of time.
Unplug the AC power cord when you are installing batteries or
when you want to operate your boombox on battery power.

Installing the batteries

You can use batteries to provide power for your CD boombox. If your
CD boombox is connected to AC power, it does not use the batteries.
To install the batteries:
1 Open the battery compartment.
2 Insert eight R-14, UM-2, or C-cell batteries (preferable alkaline
batteries) into the battery compartment. Make sure that you align
the + and – symbols with the + and – symbols inside the battery
compartment.
3 Close the battery compartment.
Caution Do not throw the batteries into fire. Dispose of used batteries as
hazardous waste.
Do not try to recharge batteries that are not rechargable. The
batteries may overheat and rupture.
4
3 Pivot for CD
4 Tuning frequency
scale
5 BAND switch
6 TUNING control
www.insignia-products.com
NS-B1110 CD Boombox