Hoover SPIRIT Manual De Instrucciones página 5

To access the exhaust filter:
1. Press the exhaust filter grid latch to access to the exhaust filter from rear of the cleaner.
[20]
2. Remove the exhaust filter from the grid. [21]
3. Gently tap and wash the exhaust filter, do not use hot water or detergents. Remove
excess water from the exhaust filter and leave to dry fully before re-using. [22]
4. Refit the exhaust filter to grid once fully dry and refit the exhaust grid.
IMPORTANT: Do not use the product without the exhaust filter fitted.
Removing a blockage
1. Check if the dust container is full. If so refer to 'Emptying the dust container' .
2. If the dust container is empty but suction is still low:
A. Do the filters need cleaning? If so refer to 'Cleaning the washable filters' .
B. Check if there is any other blockage in the system - Use a rod or pole to remove any
blockage from the extension tube or flexible hose.
C. Check if pre-motor filter is fitted and filter door is closed.
Warning (Certain models only*) -. If the cleaner is used for a significant period of time
when dust container is full, filters are dirty and with a blockage in the system, a thermal
cut out will switch the cleaner off to prevent overheating. If this should happen, switch the
cleaner off, unplug and correct the fault. It will take about 30 minutes for the cut out to
automatically reset.
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• Is the dust container over-filled? Please refer to 'Cleaner Maintenance' .
• Is the filter blocked? Please refer to 'Cleaner Maintenance' .
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system' .
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset.
Spirit_Manual ML IM.indd 3
IMPORTANT INFORMATION
Hoover Spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover
dealer or direct from Hoover. When ordering parts always quote your model number.
Consumables
• Filter kit (Pre motor and Exhaust)
Spares
• Flexible Hose
• Carpet and Floor Nozzle
• Parquet Nozzle
• Mini turbo Nozzle
uality and the Environment
Q
Safety
Although safety certification of electrical appliances is not required by law in the UK, Hoover
believe that independent approval is the best way of demonstrating safety in design and
manufacture. The British Electrotechnical Approvals Board (BEAB), the independent UK
national authority for the safety of domestic electrical appliances, ensures that European
safety standards are met and maintained throughout the production life of an appliance.
All appliances that pass the requirements are permitted to carry the BEAB mark of safety.
Quality
BSI ISO 9001
Hoover's factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
3
GB
U62 35601182
D127 35601181
G82 35600417
G87PC 35600655
J20 09200356
(*Certain Models Only)
4/5/2011 11:07:14 AM