Operation; To Switch On; To Switch Off - Furrion FCR43ACA-BL Manual De Instrucciones

Operation

Your refrigerator must stand on a
flat surface. If the appliance is to be
placed onto the carpet, support it with a
wooden board. Do not put the appliance
directly onto the carpet, because the
heat from the compressor may cause
the carpet to fade.
WARNING
• Do not set the temperature too
low, the "4" setting should be
considered cold enough as a
storage temperature.
• Do not put heavy objects (more
than 20 kg/44 lbs) on top of the
refrigerator.
• Do not put any objects on top of the
refrigerator which may fall off when
the door is opened.
• After the appliance has been
unplugged, leave for three minutes
minimum before plugging it in again.

To Switch on

Before connecting the appliance to the
mains and putting into operation for the
first time, leave the appliance to stand
for 30 minutes to allow the refrigerant to
flow into the compressor. Otherwise the
compressor may be damaged.
NOTE: If the appliance is unplugged or
power lost, you must wait 3 to 5 minutes
before restarting.
The temperature control dial has seven
settings plus 0. 1 is the warmest. 7 is
the coldest. At first, set the dial at 4.
After using the refrigerator, adjust the
dial if necessary. You can rotate the
temperature control knob to the setting
that is best suited to your needs.
Allow 24 hours for the refrigerator to
get cold.
1. Insert the refrigerator plug into the
mains socket.
2. For the first time you turn on the unit,
rotate the thermostat to "7" position.
This will make your refrigerator cool
faster.
3. Adjust the temperature to "4" setting
after 20 minutes. This setting should
be correct for home or office use.

To Switch off

1. Rotate the temperature dial to 0
position to switch off the appliance.
If the appliance is not going to be used
for an extended period:
1. Remove the mains plug.
2. Clean and dry the inside of the
appliance throughly. See section
" Maintenance".
3. Leave the door open to avoid
accumulation of odors.
8