Description Of Registers - Adeunis RF ARF868 Guia Del Usuario

ARF868 Radio Modems - User guide version V1.6

5.3. Description of registers

When switching on the ARF868 modem operates according to the last configuration saved (factory configuration if its the first switching on, or
if this configuration has not been changed).
Modification commands, type ATS<n>=<m> or ATR allow the content of registers to be modified. The product is usable with each new
configuration as long as it is not disconnected.
On the other hand the modified values will be applied next time the modem is switched on only if they have been saved AT&W command
List of the registers accessible on the ARF868 modem:
Register
Channel number : 11 and from 13 to 571
S200
Timeout to exit command mode :
0 : no timeout, exit through ATO or AT&RST
S202
1 : Automatic programmanle output from 1 to 65565 sec.
S204
X: Alternative settings for legacy X3-PRO mode
S210
S211
S212
Input character in command mode :
S214
0 : Disabling entry into command mode by UART.
0: Internal switches positions
S215
RTS/CTS UART flow control:
S216
Content
Duration of the preamble:
0: Nominal setting
UART data rate:
0 : Autobaud
1 : 2.4 kbps
2 : 4.8 kbps
3 : 9.6 kbps
4 : 19.2 kbps
5 : 38.4 kbps
6 : 57.6 kbps
7 : 115.2kbps
8 : 1.2kbps
UART data lenght :
0 : 7 Bits
1 : 8 Bits
UART parity :
0: No parity
1: Parity
2: Odd parity
ASCII code (except 0)
UART interface:
1: RS232
2: RS485, no Term mode
3: RS485, Term mode
4: Auto
0 : Inactive
1 : Active
Default value
Some channels will not be available depending on the data
rate and the selected power.
The modem will return an error message
11
Instructs the user to configure the modem according to the
possibilities described in Appendix 1
0
The choice 0 is the optimum setting. For other settings,
0
See document: Application note ARF868 Legacy X3-PRO
The other parameters of the serial interface are :
3
•
1
0
The input code is 3 times the character :
• Example : +++ if the character programmed in S214 is
43
the ASCII code of «+» wether 43
• Value between 1 and 255
Unless special request, the position of the internal switch
1 is on modem ARF868: Auto mode (same as S215 = 4). See
0
Comments
if illegal choice.
See note 4
contact Adeunis RF
mode
See note 1 & note 3
• 1 stop bit -> fixed
• Parity -> See S212
Data lenght -> Voir S211
note 2
See note 3
Page 21 of 25