Adeunis RF ARF868 Guia Del Usuario página 97

ARF868 Radio Modems - User guide version V1.6
RTS/CTS UART flow control:
S216
Transmission start-up Timeout :
S217
1 à 255 : timeout by step of 1 ms
Transmission start-up threshold :
S218
S220
S222 3: Continuous Asynchronous
4: Continuous Asynchronous «legacy X3Pro»
S230
1 : Exit «RSSI frame» on UART
4 : Exit «permanent RSSI» on UART
S231
S232
Command mode entry Timeout at 9.6kbps at product start-up.
S241
S252
S253
Network address: from 1 to 254
Radio data rate valid only with continuous asynchronous
S254
Radio data rate valid only with asynchronous continuous
11: 10Kbps (Legacy X3-PRO)
S256
Broadcast function : 65535
Note1: La modalità Autobaud autorizza il modem a sincronizzarsi automaticamente quando viene messo sotto tensione sulla velocità del colle-
0 : Inactive
1 : Active
0 : no timeout
From 1 to 1024 octets
Communication mode
0 : Transparent
1 : Addressed
Radio protocol
RSSI mode:
0 : no RSSI
RF radiated power:
0 : 27 dbm
1 : 25 dbm
2 : 23 dbm
3 : 20 dbm
4 : 17 dbm
5 : 14 dbm
6 : 10 dbm
Low Power modes :
0 : no Low power
0 : disabled
1 : enabled
Source address (or local)
from : 1 to 65535
Network number
no network : 0
255=broadcast
mode:
1: 2,4Kbps
3: 9,6Kbps
6 : 38,4kbps
8: 57,6Kbps
Legacy X3-PRO
12: 57.6Kbps
Destination address :
From 1 to 65534
0
If #0, transmission starts when the timeout has passed, if
3 the threshold of the S218 register is not reached.
The transmission starts when the number of bytes in FIFO
30 memory to reach this threshold.
0
3
0
0 : on ARF7940
and 7941 ver-
sions
5 : on ARF7942
and ARF7943
versions
0
1
Factory pre-ini- Used in the addressed mode. This register contains the
tialized
0
11 and 12 : For compatibility with X3Pro modems
1
In addressed mode, this register must be set with the
0
address of the modem to achieve.
See note 3
See note 5
See note 5
address of the modem
Page 22 of 25