Replacing And Adjusting The Centre Belt; Air Filter; Oil Change; Fuel System - KLIPPO EXCELLENT S Manual De Instrucciones

• A new belt stretches and becomes longer, so adjust
the belt again after a few hours of operation.
• Fasten the wheel and the belt cover and test run the
machine.
Replacing and adjusting the
centre belt
The centre belt runs between the engine shaft and the
gearbox.
Adjusting the centre belt
• Unscrew the adjuster screws a few turns.
• Adjust the belt by moving the gear forwards or
backwards.
• The belt should be stretched so that it can move
10mm in the centre. That corresponds to a pull of
approx. 3 kg. Use a fishing scale to check.
• Tighten the adjustment screws properly.
• Check the drive operation, as adjustment of the gear
affects the belt tension in the gearbox.
Replacing the centre belt
• Remove the cutter.
• Loosen the adjustment screws.
• Replace the belt with a new one and tighten the
adjustment screws a little.
• Adjust the centre belt. See instructions under the
heading "Adjusting the centre belt".
• Assemble the blade.
16 – English
MAINTENANCE
Air filter
• Remove the air filter cover and take out the filter.
• Clean the filter by knocking the filter against a flat
surface. Never use solvent with petroleum, for
example, kerosene, or compressed air to clean the
filter.
• An air filter that has been in use for a long time cannot
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals. A
damaged air filter must always be replaced.
• When reassembling, make sure that the filter
completely seals against the filter holder.

Oil change

• Empty the fuel tank.
Excellent S H, Comet S H, Pro 19 S H Close the fuel
•
tap.
• Unscrew the oil filler cap.
• Place a suitable vessel to collect the oil in.
• Drain the oil by tipping the engine so that the oil runs
out through the filler pipe. Ask where you can dispose
of surplus engine oil at your local petrol station.
• Fill with new engine oil of a good quality. See
instructions in the section "Technical data".

Fuel system

• Check that the fuel cap and its seal are not damaged.
Excellent S H, Comet S, Comet S H, Pro 19 S H,
Inside the tank cap you will find a clock-shaped screen
and a rubber membrane to prevent evaporation
losses. The threaded spiral functions as a vent. If the
tank cap breaks, it is important to replace it with an
original cap appropriate for that particular engine.
• Check the fuel hose. Replace if necessary.

Recycling

This machine has the prerequisites to last for many years.
This minimizes the machine's environmental impact.
Perform service and maintenance according to the
instructions in this manual. This way the engine will last
longer and the hazardous emissions are minimized.
When the machine is worn out it should be disposed of for
recycling, either to the dealer or directly to Klippo. The
machine is dismantled and the parts are divided up in
different materials for recycling. Most parts of this
machine are recyclable.