Werner L100030 Instrucciones Para El Usuario página 10

L A
IFELINE SSEMBLY CONTINUED
R T
OPE ENSIONER
The Rope Tensioner is used for coarse adjustment of the rope on systems
incorporating the Tension-Indicating Ratchet. For systems that do not incorporate
the Tension-Indicating Ratchet, the Rope Tensioner is designed to achieve
proper tension of the Synthetic Rope Horizontal Lifeline. The Rope Tensioner is
constructed with high tensile steel.
R
OPE
The low stretch 5⁄8 inch (15.9mm) Kernmantle rope is constructed with a nylon
strand core and a polyester jacket, providing a 10,000 pound (44.5kN) minimum
breaking strength. The abrasion-resistant jacket is designed to show damage
before the load carrying core becomes damaged. The rope should be removed
from service if the outer sheath is damaged. The rope comes with one end
fi nished (thimble and stitched) with a snap hook, and the other end is knotted to
prevent the rope from passing back through the Rope Tensioner.
O-R
INGS
The 2 inch (50.8mm) O-rings are made from high tensile steel and marked to
ANSI Z359.1-2007 and/or ANSI Z359.12-2012 with a minimum breaking strength
of 5,000 pounds (22.2kN).
INSTALLATION
WARNING!
All components of the Synthetic Rope Horizontal Lifeline
must be inspected prior to each use in accordance with
the requirements of OSHA 29 CFR 1910.66 and 1926.502.
B E U
EFORE ACH
Users must have a rescue plan, and the means to implement it, that provides for
the prompt rescue of employees in the event of a fall or assures that employees
are able to rescue themselves.
The user must read and understand these User Instructions, as well as the
User Instructions for every component and subsystem of the personal fall arrest
system.
Page 10
SE