Maytag MVWX5SPAW Manual De Uso Y Cuidado página 13

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/help
If you experience
Washer not performing as expected (cont.)
Washer won't run Check proper electrical supply.
or fill, washer stops
working or wash light
remains on (indicating
that the washer
was unable to fill
appropriately) (cont.)
Normal washer operation.
Washer may be tightly packed. Remove several garments, rearrange load evenly around the washplate.
Not using HE detergent
or using too much
HE detergent.
Washer not draining/
Empty pockets and use garment
spinning, loads are
bags for small items.
still wet or spin light
Use a cycle with a low
remains on (indicating
spin speed.
that the washer was
unable to pump out
water within ten
minutes
The washer may be tightly
packed or unbalanced.
for assistance and to possibly avoid a service call.
Possible Causes
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not interrupt cycle.
Washer may be stopped to reduce suds.
The washer senses the dry load with short spins that may take 2 or 3
minutes before water is added. You may hear the hum of the spins. This
is normal.
Do not load garments directly over the center of the wasplate. Close lid
and press INICIO/PAUSA/DESBLOQUEAR TAPA (Start/Pause/Unlock).
Add only 1 or 2 additional garments after washer has started.
Do not add more water to the washer.
Only use HE detergent. Suds from regular detergents can slow or stop
the washer. Always measure detergent and follow detergent directions
based on your load requirements.
To remove suds, cancel cycle. Select ENJUAGAR & EXPRIMIR (Rinse &
Spin). Press INICIO/PAUSA/DESBLOQUEAR TAPA (Start/Pause/Unlock).
Do not add more detergent.
Small items may have been caught in pump or between basket and tub,
which can slow draining.
Cycles with lower spin speeds remove less water than cycles with high
spin speeds. Use the recommended cycle/speed spin for your garment.
To remove extra water in the load, select DRENAR & EXPRIMIR (Drain &
Spin). Load may need to be rearranged to allow even distribution of the
load in the basket.
Tightly packed or unbalanced loads may not allow the washer to spin
correctly, leaving the load wetter than normal. Evenly arrange the wet
load for balanced spinning. Select DRENAR & EXPRIMIR (Drain & Spin)
to remove excess water. See "Using Your Washer" for loading
recommendations.
Solution
13