Yakima LITERIDER 2 Manual Del Usuario página 4

Apply Zip Strips, diagonally over frame, hook into place.
Load additional bikes.
use the included safety strap to secure your bikes to the carrier.
Route the strap through each wheel, around the carrier. Feed the
strap through the buckle, tighten it down, and secure the loose end.
Fold mast down to access the rear:
• unload the bikes.
• push the top of the mast towards
the vehicle while pulling the release
knob upward simultaneously.
• carefully fold mast down.
• When finished be sure to bring the
mast to the full upright and locked
position.
CAUTION: Keep fingers away
from ALL moving parts!
CAUTION: NEVER operate vehicle with LITERIDER in folded position!
Check that release knob is in locked position by pulling on mast.
Fold carrier arms when not in use.
Be sure arms
lock in down
position.
1035681C-4/15
PULL
• pull release lever
forward.
• pull up slightly on arms
while pulling lever.
• Fold arms.
Arrange bikes for best stabilization.
pull straps tightly over bike frame,
and hook onto cradle.
Alternate bike directions to
avoid interference.
To lock bikes to LiteRider use lock cable.
• Access lock cable from recess at rear of mast.
• pass cable through bike frame.
• Attach lock to pin at end of the arm.
• lock the lock.
safety strap
Never fold
down mast
with bikes
loaded.