Fitting; Fitting Mechanical Components - Festo DGC-8 63 Serie Instrucciones De Utilizacion

DGC
6

Fitting

Fitting mechanical components

Prevent the sealing band from being pressed or sucked in.
S
Damage to the sealing band reduces the operating reliability. A sudden jerk
movement of the pressureless slide can create a low pressure which sucks the
sealing band into the piston chamber.
Leave all screws and threaded bolts in their original states, unless you are
S
requested to modify them in these instructions.
Avoid the band system becoming damaged or excessively dirty.
S
Damage to the DGC will reduce its reliability and service life.
Make sure that the drive is fitted free of mechanical stress and distortion.
S
Replacing a linear drive DGP(L) by a DGC:
Use the foot fastening adaptor HPC.
Slide position above:
HPC−...−SO / HPC−...−S
DGP(L)−...
DGC−GF/KF
Tightening torques for the fastening screws
HPC−8
0.8 Nm
Fig. 5
Festo DGC 0901d English
HPC−12/18 HPC−25
1.6 Nm 2 Nm
Slide position behind:
HPC−...−SH / HPC−...−S
DGP(L)−...
DGC−GF/KF
HPC−32/40 HPC−50
4.5 Nm 15 Nm
HPC−63
23 Nm
31