Default Settings; About Firmware Upgrades - Pioneer LAN Guia De Inicio Rapido

Initialization
Tip
When the unit is initialized, all settings in the unit are cleared. Before performing
initialization, note necessary information.
1
Check that the POWER lamp of the unit lights.
2
Press and hold the Reset/WPS button on the side of the unit for at least
10 seconds.
3
When the POWER lamp goes off once and then begin flashing, release
the Reset/WPS button.
4
Wait for a while and when the unit restarts, initialization is completed.
When initialization is completed, perform settings according to the procedure in "STEP 2-1
Connecting to a Wireless LAN Router (WPS button version)" (page 5) or "STEP 2-2 Connecting
to a Wireless LAN Router (Manual setting version)" (page 7).

Default Settings

The default settings at the time of shipment of the unit are as follows:
User name (login ID) admin
Password 1234
IP address 192.168.2.249

About Firmware Upgrades

Firmware upgrades are not necessary if there is no information on the Pioneer website.
16