Turning The Power On - Pioneer LAN Guia De Inicio Rapido

STEP 1
Checking the Wireless LAN Router
First of all, check the following content.
1
Check that your wireless LAN router can be connected to the Internet
without problem.
Wireless LAN
Internet
Modem
Tip
To set up the system using this step, a separate wireless LAN router is required. If you do
not have a wireless LAN router, arrange the one.
2
Check that your wireless LAN router supports WPS. You can check this in
the instruction manual for your wireless LAN router.
Note
WPS is a function that allows you to use buttons to establish a wireless LAN device
connection and set up security.
*On some devices, it is indicated as "WPS".
If the wireless LAN router has a WPS button
Set using "STEP 2-1 Connecting to a Wireless LAN Router (WPS button
version)" and STEP 3, in that order.
If the wireless LAN router does not have a WPS button
Set using "STEP 2-2 Connecting to a Wireless LAN Router (Manual
setting version)" and STEP 3, in that order.
Can connect to the
router
Internet.
Computer
STEP 2 - 1
Connecting to a Wireless LAN Router
(WPS button version)
Tip
In this step, the WPS function is used for setup. If the wireless LAN router does not provide
WPS support, refer to the Manual setting version (page 7).
Until instructed to do so in this manual, do not connect the LAN cable to this unit.
To use two or more of this unit, you need to change the IP address of the units. For details,
refer to "Troubleshooting" (page 14).

Turning the Power On

1
Turn off the power of the AV receiver.
OFF
2
Using the USB feeder cable side of the supplied cable, connect the
Power port of the unit and the USB port on the AV receiver's rear panel.
The position of the USB port and what it is called differ depending on the device. If you are
not sure about the USB port, refer to the instruction manual for your device.
The USB port is a landscape or
vertical port as shown above.
* On some devices, it is
indicated as "DC OUTPUT for
WIRELESS LAN".
AV receiver
LAN (10/100) AV receiver
DC OUTPUT
for WIRELESS LAN
( OUTPUT 5 V
0.6 A MAX )
5