Kuppersbusch EEBP6260.0 Manual Del Usuario página 26

PROGRAMMING AND OPERATING THE PYROLYTIC FUNCTION
Follow the instructions below to carry out a
pyrolytic cleaning cycle:
1 IMPORTANT: Remove all accessories
(shelves, grids, side supports to hold up
the shelves, telescopic guide rails) from
inside the oven.
2 Turn the cooking control dial to Pyrolysis
position .
3 Next, press the
should appear on the timer display.
4 After a few seconds, on the timer display,
you will see the P2 indication (programme
2 of the pyrolytic function).
5 You can now change the pyrolysis program-
me to P1, P2 or P3 by pressing the
keys:
P1: Minimum programme. Duration 1 hour
P2: Standard programme. Duration 1 hour
and 30 minutes
P3: Maximum programme. Duration 2
hours
6 You will hear 2 consecutive beeps after
several seconds or by pressing the
confirming the chosen programme.
7 After a short time, you will see the time
remaining for the selected programme to
end and the symbol
display. The pilot light
the oven door cannot be opened, as the
heating will have begun.
26
key, the word PIRO
or
key
lit up on the timer
will turn on and
IMPORTANT: At this point, the oven is pro-
grammed and the pyrolytic cleaning cycle is
underway. During the cycle, none of the timer
functions can be selected, except the child
lock. Do not try to open the oven door as it
may interrupt the cleaning process.
8 When the pyrolytic cleaning cycle has finis-
hed, an alarm will sound, the symbol
will flash and you will see the correct time
on the display.
9 Press any of the timer's keys to disable the
alarm.
10 Set the cooking control dial to position 0.
11 The oven's heating process has ended,
however the oven is extremely hot and can-
not be used. The cooling motor will opera-
te until the oven cools down, pilot light
will remain on and the symbol
on the timer display.
IMPORTANT
The cooling process may last up to 2 hours
owing to the high temperatures inside the
oven.
12 You will be able to open the oven door a
short time after the pilot light
IMPORTANT
To open the door (pilot light
dial must be in position 0. If you did not follow
instruction 10 set the control dial to position 0
and wait a few minutes until the door unlocks
and the pilot light switches off.
will flash
turns off.
on), the control