Kuppersbusch EEBP6260.0 Manual Del Usuario página 27

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

13 Open the oven door and wipe the inside
with a damp cloth, cleaning up the ash
from the cleaning cycle. Areas in the oven
that are difficult to access will need to be
cleaned with a non-metallic fibre scourer.
14 Once the oven is clean, do not forget to
replace the supports and accessories.
Pyrolysis is an automatic function and therefo-
re can only be activated from the timer pro-
gramme. To cancel a cleaning cycle it is neces-
sary to reset the oven, following the instruc-
tions below:
1 Set the function control at 0 and wait for 1
minute.
2 Unlock the oven door.
1 Set the function control at 0 and wait for
1 minute. The oven will no longer heat up.
2 Unlock the oven door. To cancel the clea-
ning cycle, the oven door must be unloc-
ked. To do so, consider the following:
CANCELLING THE PYROLYTIC CYCLE
15 The oven is now ready to be used.
IMPORTANT: If any incidents are detected in
the programming and operating of this func-
tion, consult the section "Incidents while
Operating the Pyrolytic Function".
a) Unlocking the door 45 minutes after
the cleaning cycle. If the oven has been
operating for more than 45 minutes, the
door will unlock automatically once the
oven has cooled down to the safe tem-
perature. Then, pilot light
off.
b) Unlocking the door in the first 45 minu-
tes (at a low temperature). Within the
first 45 minutes the oven door will
unlock automatically. Follow the instruc-
tions below:
1 Turn the control dial to position
2 Wait for approximately 1 minute.
3 Turn the control dial to position 0.
4 Approximately, 1 minute later pilot
light
will turn off and the oven
door can be opened.
will switch
.
27

Publicidad

Tabla de contenido
loading

Tabla de contenido