Functional Description - Milwaukee 6480-20 Manual Del Operador

FUNCTIONAL DESCRIPTION

1
12 11 2
19
18
1. Indexing pins
2. Torque knobs
3. Handle
4. Switch
5. Lock
6. Hex wrench
7. Saw motor
8. Carriage
9. Spindle lock
10. Chatter guard
(not shown)
2 3
10 9
13
14
15
16
18
11. Blade guard
12. Carriage lock
13. Saw motor cord
14. Cord keeper
15. Counterbalance
16. Counterbalance cable
17. Frame of tool
18. Guide tubes
19. Rear guard
Volts .............................................................120 AC
Amps ...................................................................15
Speed ..............................................................6300
Cat. No. ..................................................... 6480-20
Blade Size ..................................................... 8-1/4"
Arbor ................................................................. 5/8"
4
Capacity*
Thickness ................................................... 1-3/4"
Height ............................................................. 50"
5
Motor Only. ............................................... 6486-20
* For additional limitations, see the "Rip Cutting" and "Cross-
6
cutting" sections.
7
WARNING
8
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
To avoid injury or damage to the tool, follow the order
of sections in "Tool Assembly". Set up the tool in the
following order of sections:
1. Setting up the Stand
2. Installing the Counterbalance
3. Mounting the Saw Motor
4. Installing Blades
5. Adjusting the Rulers
6. Installing the Blade Guard
7. Installing the Cord Keeper
Use at least two people to remove packaging and
set up the stand. One person should hold the stand
in an upright position while the other removes the
packaging and sets the folding stand to make the
tool free-standing.
17
Folded locking
pin position
Sliding
center bar
Unfolded locking
pin position
Locking pin
Center bar
Stand base
1. While having another person hold the stand in the
upright position, stand behind the tool. Remove the
locking pin from the folded locking pin position with
one hand while holding the stand base with your
other hand so it does not unfold onto your feet.
2. Unfold the stand slowly until the hole in the sliding
center bar is aligned with the hole in the center
bar.
3. Insert the locking pin through the holes and lock
it securely.
5
SPECIFICATIONS
ASSEMBLY
To reduce the risk of injury, always
unplug tool before changing or
Assembly Order
Setting up the Stand