Fitting Instructions - Rola 59636N Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Step 3: Fitting Cross Bars to the vehicle

A. Place an end support into the plastic adaptor and

loosely bolt down by inserting the 55mm bolt into the

anchor point threads and turning approx 2-3 turns

with the L wrench security key. Do not tighten yet,

Repeat for the opposite side. (fig 4)

Place the cross bar onto the end supports ensuring

that the end support tabs are located into the cutouts

on the underside of the bar. Check that the cross bar

has equally distanced overhang on either side of the

end supports. (fig 5)

Insert the M8 hex nut into the clamp plate. Insert the

clamp plate into the end of the cross bar and align it

so that the nut and the end support's bolt hole align.

D. Secure the cross bar to the end support by screwing

the M8 x 20mm bolt with washer and spring washer

through the end support hole and into the clamp

plate nut. (fig 6)

Using a 13mm or adjustable wrench fully tighten the

bolt on the underside of the support. Now using the

security key finish tightening the 55mm bolts to 5Nm

(44 in/ lbs) or to a firm hand tightness.

Step 4: Installing under cover strips

Mark on bars with a pencil the length of under

cover strips needed.

Remove bars, measure length of under cover filler

strips to fill slot. Cut under cover pieces using

scissors or a blade. Slide inner most under cover

into position on the bars and re-assemble bars onto

vehicle. Add the outer under cover piece once bars

are attached. (fig 7)

Step 5: Install end caps

Locking end caps can now be installed into the ends of

the cross bars. Remove keys and keep in a safe place.

To load accessories into the cross bar accessory

channel remove end cap, cut buffer strips as needed.

Once accessories have been loaded, re-insert the end

caps and lock. Additional buffer strips may be

purchased from ROLA if needed.

REGULARLY CHECK THE TIGHTNESS OF CROSS BAR ATTACHMENTS.

Loads should be evenly distributed and secured

Check the function of all doors and sunroof before driving.

Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle

should therefore be driven with increased caution.

For lost key replacement or other service items call customer service: 1-800-632-3290 or visit:

Please have lock core number or part numbers available.

Only use NON-STRETCH tie down straps.

A number of accessories for carrying special loads are available.

59636N

REV 8-24-15