Step 4. Connect The Power Supply; Step 5. Connect The Usb Cable - HP Scanjet G4000 Series Guía De Instalación Y Asistencia Técnica

Chapter 1

Step 4. Connect the power supply

The power supply has an attached cable that plugs into the back of the scanner.
The power supply also has an AC cable that is connected to the power supply on one
end and plugged into a power outlet or surge protector on the other end.
1. Plug the AC cable into the back of the power supply.
2. Plug the other end of the AC cable into a power outlet or a surge protector.

Step 5. Connect the USB cable

Caution
the HP Photosmart software before connecting the scanner to your computer
with the USB cable. See Step 2. Install the software on page 5. If you are
installing in a Macintosh environment, you can connect the USB cable either
before or after installing the software.
6
If you are installing in a Windows environment, be sure you install
HP Scanjet G4000 series