Extension Rail; Gold 5/16" Flat Head Screw - Sauder Transit L Desk 414417 Manual De Instrucciones

Step 2
Separate the EXTENSION SLIDES (AA) from the
å
EXTENSION RAILS (Z) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (Z) to the LOWER END (A)
å
and CENTER UPRIGHT (D). Use four GOLD 5/16" FLAT
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END and UPRIGHT. Turn
a SCREW into this hole.
Push the black lever in and pull the SLIDE from the RAIL.
1
Open end
Finished edge
Page 6
AA
3
2
A
Z
Z
3
D

GOLD 5/16" FLAT HEAD SCREW

(4 used in this step)
414417
Remember:
Righty tighty.
Lefty loosey.
Open end
1
Z
2
Finished edge
3S
www.sauder.com/services