Back; Extension Block; Ballast - Sauder New Grange 419142 Manual Del Usuario

Step 11
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (J) and lay it over your unit.
Make equal margins along all four edges of the BACK (J). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (J) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHTS (E and F).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Fasten the BALLAST (Z) to the BOTTOM (H). Use three
å
BROWN 1" FLAT HEAD SCREWS (12S).
Fasten the EXTENSION BLOCKS (Y) to the BOTTOM (H). Use
å
four BLACK 7/8" FLAT HEAD SCREWS (31S).
Push two PLASTIC FEET (20E) into the holes in the
å
EXTENSION BLOCKS (Y).
BROWN 1" FLAT HEAD SCREW
(3 used for the BALLAST)
Finished surface
BLACK 7/8" FLAT HEAD SCREW
(4 used in this step)
Page 16
12S
Y
20E
31S
31S
These holes must line up over
the UPRIGHTS (E and F).
J
Z
H
Y
20E
Finished surface
419142
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(66 used in this step)
This hole should be here.
www.sauder.com/services
1N
NAIL